Novorodapie Inox - Stainless steel skirting board

Skirting board profile made of AISI304 stainless steel. With smoothed visible side, is very easy to install with common adhesives. It is delivered with protective film to avoid possible stains or damage during the handling or transport. Available in high brightness and brushed finishes and with all the complementary pieces needed.

Available in Stainless Steel High Brightness and Brushed finishing. For a perfect finish off, there are COMPLEMENTARY PIECES AVAILABLE: Internal and external angle and the cover.

Dimensions

• a: 60 mm
• h: 10 mm
• Long: 2,50 ml

Materials

Skirting board profile made of stainless steel AISI-304. All material batches are tested with the composition test to determine that they fulfill with the specification of the alloy. Stain-less steel used has been also tested with salt spray test, exceeding 500 hours of exposition without signs of corrosion.

Stainless steel is a highly durable and resistent material, with an excellent superficial appearance that does not degrade along the time. Available in brushed finish. This finish is slightly porous and smooth, making easier the hygiene of the installation.

The complementary pieces are made of folded stainless steel sheet.

Installation

1. Clean the inner side of Novorodapie Stainless steel and the surface where is to be placed.
2. Join the complementary pieces to Novorodapie Stainless steel. This previous step will help to install the whole set to the wall. To keep the pieces in its position, you can use an adhesive tape as help. Be careful and remove partially the protective film on the areas in direct contact with the wall.
3. Thirdly, put a big amount of adhesive on the inner side of Novorodapie Stainless steel in the areas in contact with the wall. You can use an adhesive like silicone or polyurethane mastic.
4. Place the Novorodapie Stainless steel on the wall and press softly to get a perfect adhesion. Be sure the complementary pieces remain on their correct position.
5. Finally, clean the leftover material an let dry. After drying, remove the protective film.

*If you are going to paint the wall, keep the protective film until you have finished. 

Cleaning and maintenance

The immediate cleaning of the material after its installation is necessary to avoid that remainings of mortar, concrete or iron particles from wool or tools could cause corrosion.

For indoor applications, you can use water with detergent or liquid soap to remove dirtiness and pos-sible fingerprints marked on the surface. In high brightness finishes, you can use a glass cleaner. There are specific cleaners in the markets for stainless steel which clean the material and reduce possible stains. Whenever you clean stainless steel, ensure you rinse it well and dry totally to prevent fogging.

Steel  wool  or  similar  products,  are  not  recommended  because  they  could  scratch  the  surface  and  create pitting corrosion. Pay special attention while using materials containing chlorides, they are not indicated because could oxidize the material. Hydrochloric acid or iron products in a long contact with the  material  are  neither  recommended.    Do  not  use  cleaners  for  common  steel  for  the  cleaning  of  stainless steel.